Custard wrote:Stood at the Radiator looking towards the battery you can see the manifolds on the right.
The cast iron is the exhaust and the alloy is the inlet.
So four cylinders two valves for each.
So from the front
Exhaust Cylinder 1
Inlet Cylinder 1
Inlet Cylinder 2
Exhaust Cylinder 2
Exhaust Cylinder 3
Inlet Cylinder 4
Exhaust Cylinder 4.
old english white wrote:There are many more Morris Minor parts specialists than just ESM aren't there. In all the years I've run Minors I've never been stuck for parts after a few telephone calls.... Just do a bit of phoning around
Custard wrote:Engine parts are often the same as a mini so mini suppliers should be considered as well.
Is this what you are after?
http://minispares.com/product/Classic/E ... ssic/valve collets.aspx|Back to search
Custard wrote:Ah, I see, you have the external clips as well then like this?
Scroll down a bit cylinder head on its side on the left.
http://www.rick-ford.co.uk/EBay/12G202f ... 2fiona.htm
Unfortunately I had some on an engine that went complete.
Custard wrote:I am not sure why the clips are there to be honest.
The collet is wedged in the cap when the valve spring pressure is there.
I would have thought there is more chance of a spring falling off than there is of a collet without a spring coming loose.
Though there are valves with three grooves and then the collet has three as well.
I must admit I am not sure of the history, which engines got which valves etc.
My 1275 is using the collets like your new one i.e. single internal groove no external one.
I would post up in the wanted section as someone may have a box of spares from old heads.
Users browsing this forum: No registered users and 2 guests